Language:
4 channel S0 pulse counter with RTU MODBUS, RS485, S0 Standard 62053-31, to Teracom data loggers
Product code: TDI340
TDI340 is an S0 pulse counter with MODBUS RTU interface. It has 4 isolated digital inputs that complies with S0 standard 62053-31. S0 pulse counter operates in polling or level-shift mode. In the level-shift lstand the module can be set to count on rising, falling and both level changes. The unit is a dedicated S0 pulse counter, but it also provides simultaneous readings of the state of digital inputs - OPEN / CLOSE.
Independent delay for transitions from low to high and high to low can is used. It may be delays from 0 to 656 seconds in 10mS steps and works if the counter for the corresponding digital input is in polling mode.
TDI340
1 Item
Remote collection of data, remote meter monitoring, energy management
Energy Meter Interface Module with MODBUS RTU
RS-485 interface with up to 63 units per BUS
Built-in 120 ohm termination resistor
Flash memory data and setup
Power supply from 5 to 32VDC, 25mA at 5VDC
Galvanic isolated digital input - 10mS pollinghastighed
Optional inputs: Open / Closed (dry contact and 32 bit counter)
S0 pulse counter applications :
Remote monitoring of electricity meters
Industrial process control
Remote monitoring of gas meters and water meters
monitoring devices with S0 outputs;
process monitoring
DIN rail mounting
Firmware update via interface.
Dim: 35 x 86 x 59 mm