Language:
1-wire temperature and moisture sensor for web-based X-4XX and X-600M controllers. -40- +80°C, 0 - 100% RH.
Product code: X-DTHS-P
X-DTHS-P is a new sensor and temperature sensor sensor used with many of the 400 series, X-600M and WebRelay-Wireless products. Temperature and humidity are accurately measured, digitized and sent to the ControlByWeb module via a serial 1 thread data bus. One or more sensors can be connected to the 1-wire bus and the cable can be extended up to 180 meters from the module without loss of measurement accuracy. X-DTHS P comes with two mounting options: Mounting terminal - assembly against a surface. Thru-Wall Mounting Bracket. The bracket has a foamback that seals the access hole. Temperature / moisture sensor with accessories for wall mounting.
The sensor can be installed outdoors, but must be protected from the elements. Install the sensor in a protected place away from rain or direct sunlight. No additional software or power supply required. Simply connect and configure on one of our compatible products. Temperature sensor wiring: The sensor has three wires connected to a compatible controller device. If necessary, the cable can be extended with additional wire (max. 180 meters).
X-DTHS-P
1 Item
1-wire combi sensor for temperature and moisture
3 connections: + 5VDC, GND, data
Max. Length of cable for controller: 180 meters
Mounting bracket for wall
Mounting bracket for Implementing
Temperature range: -40 - + 80 ° C
accuracy: ± 0.4 ° C (0 ° C to 80 ° C)
humidity: 0 - 100% RH
not suitable for environmental environments with repeated or prolonged condensation
accuracy: ± 2%
Sensor type: Digital 1 leader (Maxim DS18B20)
Cable length: 3 meters
probe length: 10 cm